When speaking of hydraulic pumps, the most commonly used and ideal pump is the centrifugal pumps. It finds its application in the domestic and industrial facilities. You may ask why are centrifugal pumps so popular? The reason is that they can induce flow or even raise pressure of a fluid. It has a simple working mechanism.
Construction of the impeller:
However, a centrifugal pump cannot work without this thing called the impeller. It lies at the center of the system. An impeller is basically a rotating structure with a series of curved vanes/blades. These blades are fitted inside the shroud plates and immersed in water. The engine or the motor shaft that the impeller is connected to produces centrifugal force within the pump casing.
Working of the impeller:
When the impeller rotates, the fluid surrounding it also rotates. The water flows out radially through the centrifugal force imparted by the impeller. The pressure and kinetic energy of the water rises at the discharge side of the impeller because the rotational mechanical energy is transferred to the liquid. On the other hand, a negative pressure is induced at the eye on the suction side of the impeller where water is getting displaced. The centrifugal pump impeller when works in tandem with the volute helps to create a partial vacuum and a low pressure. When this vacuum is is maintained it helps to the fresh water stream to move into the system.
The centrifugal pump impeller combined with the volute decides the following:
- flow of the pump,
- pressure inside the pump and the liquid
- the solid handling capacity of the centrifugal pump.
One of the most frequently used and popular type of centrifugal pump impellers is the open impeller. Their specialty is that can even pump liquids containing suspended solids. These materials usually include twigs, slurries etc. Open impellers do not clog easily since they have an external adjustment that helps in their maintenance and clearance when the internal parts begin to wear.
How can you achieve a higher efficiency in centrifugal pumps?
For a commendable centrifugal pump performance, the front side of the vanes must be set with a clog clearance. However, with time, the impeller and suction plate will start wearing out. With that, the performance of the pump will also start deteriorating. But still if we regularly carry out clearance checks and make sure that the periodical adjustments are done, we can maintain the good performance of the pump.
We can also increase the clearance behind the impeller by adjusting it towards the suction wear plate. The vanes are located on the non-pumping side of the impeller are called back pump-out vanes. These are smaller in size and can act like another centrifugal pump. They also help in maintaining a low pressure. So that is the reason why it is necessary to keep the impeller in a good shape. The performance of the centrifugal pump is largely based on the impeller!
TOBEE PUMP ENGINEER